PhrozenGO 4+

The idea is nice, get status of your print... Camera is pretty useless, I removed it and put a heater in its place. To make it useful it needs to take a picture at every lift cycle. With the "capture" button you roll the dice to try to catch it on a lift cycle and even the you're not going to see anything unless it's almost done, the pic quality is horrible and it needs to be wider angle to ensure you get the items in frame. Status notifications are a hot mess. It tells me the print is done, over and over and over and over and over and over and over and over and over and over and over and over and over and over and over again (Get the idea?)

I got my printer late April 2024, started using it May, 2024. The app was pretty smooth, connected it to the might Revo and everything was good.

Sometime in June an update was done. Since then the app is very laggy and errors when trying to take pictures. Even opening the app and seeing the list of printers (in this case 1 printer) it takes forever to recognize. Once you click the printer it takes even longer to load the details. Not sure what they changed but a huge step backwards.

Is there more I wish I could do with the app. Sure. I’d love to run Timelapse videos through it of the printing process and I do wish the camera had a built in led so the pictures came out better. But, it’s doing what it says it does. It allows me to monitor my print and take photos through the Mighty 8k built in camera. Setup was easy and straightforward. No real complaints so far using the app.