moneo|blue 4+

New:
- Landscape is disabled for the app. The app will always stay in portrait mode
- When the connection was lost to an IO-Link device because the IO-Link device was removed, then the user can press the refresh button or go back.



Changes:
- several typos, spellings, wordings corrected


Bug fixes:
- For a base station that is connected to several Mesh adapters, when the user disconnects one Mesh adapter and reconnects the same again, then the refresh of the base station overview gets stuck. Now the base station overview refreshes consistently after reconnect.
- If directly connected Mesh adapter is disconnected while a firmware download is ongoing, then user is informed by a popup.
- When user provisioned a mesh adapter then on the Base overview page inside the related tile a (wrong) message will be shown that the adapter would be disconnected. Now the correct information of the adapter is shown.
- Reset the firmware update state after a successful reconnection.
- The progress bar gets stuck if the user retries to read the parameters of a sensor after sending an IO-Link command to the sensor.
- When internet is OFF and IODD cannot be downloaded then show an error message.
- Modified IO-Link parameter should be discarded when user leaves the device parameter page.
- For VVB sensor, the process value and the unit of measurement mismatch on device info page and parameter page.
- After a connection loss and after the user pressed the cancel button and the app redirected to the home page, still the "failed to connect" popup occured on the home page.
- In the sensor parameterization, the OK button of the drop down box did not allow to tap on the OK button for changed values
- Password view option did not work when you enter the password and directly press on the view option. It did not display password. The behaviour of the "view" button is now as expected and used widely in apps.
- In iOS the radio button text overlaps other buttons
- The app changed the language only if the user changed the region. Now the app changes the language if the user changes the system language.- For the DV sensors, when the user comes back from the configuration page to the device info page then the image for the sensor was not displayed. Now all relevant information is shown to the user.